Elan Z-600 Installation Manual download pdf (Page 30)

ELAN HOME SYSTEMS

INSTALLATION MANUAL

5.9 MULTIPLE

630 SYSTEM

CONNECTIONS

1. Decide which Z•630 will be your MAIN (Zones 1-3) and

which chassis will be AUXILIARY (Zones 4-6, 7-9, 10-

12).

2. Peel back the Lexan strip on the front panel of the

AUXILIARY Z•630(s), and assign chassis ID numbers

to the AUX units using DIP Switches #4 and #5. (See

page 9 for the appropriate Chassis ID settings for each

Z•630. NOTE: The “MAIN” Z•630’s #4 and #5 DIP

Switches should remain in the DOWN position.

3. If not utilizing a PZ6 Precision Panel, connect RS485+/-

connections between all the Z•630s in the system. (See

details on page 26).

4. Source components should be connected to the MAIN

Z•630 first, then looped out from the MAIN Z•630 to the

AUX Z•630s (see SOURCE CONNECTIONS on page

22).

5. IR emitters for each source should be connected to the

corresponding outputs on the “MAIN” Z•630’s IR output

ports. (See IR EMITTER CONNECTIONS on page 23).

6. Use ELAN C4545 RJ45-to-RJ45 interconnects to link

each each of the Z•630’s IR LOOP IN/OUT ports

together.

7. Keypads, VIA! Panels, and/or IR Receivers are connect-

ed as follows:



Zones 1-3 to CHASSIS 1(MAIN).



Zones 4-6 to CHASSIS 2.



Zones 7-9 to CHASSIS 3



Zones 10-12 to CHASSIS 4

(See pages 25 and 26 for more detailed information).

8. Connect the Zone Outputs of each Z•630 to the amp

channels dedicated to each zone (not shown).

SERIES II

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

No comments

Elan Z-600 Installation Manual Page 30